Introduction of Block adhesive tbg tbw

Introduction

Gray and white block adhesive is for binding the AAC autoclaved lightweight concrete blocks.

Preparation Instructions

Mix the contents of the bag with 6.5 liters of clean water in a mixer and wait 10 minutes after reaching a uniform concentration (processing time) and after this time, mix the mortar for a short time (about 15 seconds) again.

Standard:

The product complies with International Standard EN998-2

Description

Method of use

Spread the prepared mortar on the block with a thickness of 3 to 5 mm, then create slots on the layer with a notched trowel. Adjust the stacked blocks with a rubber hammer from above and the side.