Description
Method of use
Spread the prepared mortar on the block with a thickness of 3 to 5 mm, then create slots on the layer with a notched trowel. Adjust the stacked blocks with a rubber hammer from above and the side.
Introduction
Gray and white block adhesive is for binding the AAC autoclaved lightweight concrete blocks.
Preparation Instructions
Mix the contents of the bag with 6.5 liters of clean water in a mixer and wait 10 minutes after reaching a uniform concentration (processing time) and after this time, mix the mortar for a short time (about 15 seconds) again.
Standard:
The product complies with International Standard EN998-2
Method of use
Spread the prepared mortar on the block with a thickness of 3 to 5 mm, then create slots on the layer with a notched trowel. Adjust the stacked blocks with a rubber hammer from above and the side.
Reviews
There are no reviews yet.